Skip to main content
WillVitale
Contributor
Mar 27, 2024 9:47 PM UTC
Solved

Scenario Type 3 Not Showing Up in Workflow Profile

Hello,

I created a new Scenario and assigned it as ScenarioType 3. I went into Application Properties and made sure ScenarioType2 general and dimensions were set up for it. I then went into the Workflow Profile and created a new Form under one of the workflow and it is not showing up. Did I miss something when I setup the new scenario?

WillVitale_0-1711575931634.png

Thanks,

Will

    NoemiAnswer
    OneStream Employee
    Mar 28, 2024 3:20 PM UTC

    Hey Will, I can see that on your first screenshot you are looking at a workflow profile under the Consol_ACT Cube Root WF profile but on your cube setting the suffix assigned to Scenario Type3 is AUD. If you want to see ScenarioType3 on a WF profile under the _ACT you need to assign the same suffix. Otherwise you can create a new cube root WF profile (Consol_AUD) and create a new WF profile under that and your ScenarioType3 will be there.

    View in thread

    4 replies

    Employee - Sage
    JackLacavaEmployee - Sage
    Employee - Sage
    Mar 28, 2024 11:22 AM UTC

    Make sure you refresh the application (the big white/green refresh icon on the top bar) and then refresh the Workflow Profiles page (close and reopen, or the small refresh icons on the middle bar).

    Also, you're looking at a Cube Root Profile with a suffix (_ACT), so make sure you've added that suffix to your ScenarioType3 in Cube Properties.

    WillVitaleAuthor
    Contributor
    Mar 28, 2024 3:08 PM UTC

    Hey Jack,

    I tried that before and still got nothing, so maybe I'm missing something else?

    I went in the Cubes and went into Cube Properties and Cube Dimensions to make sure everything was set up for ScenarioType3 and still nothing is showing up. Any other thoughts?

    WillVitale_0-1711638484841.png

    WillVitale_1-1711638506954.png

    Will

    OneStream Employee
    NoemiOneStream EmployeeAnswer
    OneStream Employee
    Mar 28, 2024 3:20 PM UTC

    Hey Will, I can see that on your first screenshot you are looking at a workflow profile under the Consol_ACT Cube Root WF profile but on your cube setting the suffix assigned to Scenario Type3 is AUD. If you want to see ScenarioType3 on a WF profile under the _ACT you need to assign the same suffix. Otherwise you can create a new cube root WF profile (Consol_AUD) and create a new WF profile under that and your ScenarioType3 will be there.

      WillVitaleAuthor
      Contributor
      Mar 28, 2024 3:27 PM UTC

      Oh I didn't know that! Thank you so much. That worked 🙂

      Will

      Terms & ConditionsAccessibility statement