Skip to main content
A
AndreaF
Expert
March 27, 2023
Solved

Prompt users for parameters selection when running a pre-process step

  • March 27, 2023
  • 1 reply
  • 0 views
Hi, I have a data management step/data management sequence that use member dialog parameters, which means users are prompted for the parameters selection when running them.
AndreaF_0-1679921720469.png

 

I have attached the data management sequence to a Pre-process step of a workflow (via calculation definition, setting the filter value equal to the data management sequence name and using a DataQualityEventHandler rule). However, when running the Pre-process step the data management sequence runs using the default values for the parameters and users are not prompted for the parameters selection. How do I make so that users are prompted for the parameters selection when running the Pre-process step?
Best answer by JackLacava

As far as I know, you can't - the Process interface is not meant to be interactive.

You could retrieve values in your rule from some predetermined but easy-to-maintain place, typically the Text1-4 properties in the workflow profile where you have the Process step (using .GetAttributeValue on the profile object).

1 reply

J
OneStream Employee
JackLacavaOneStream EmployeeAnswer
OneStream Employee
March 28, 2023

As far as I know, you can't - the Process interface is not meant to be interactive.

You could retrieve values in your rule from some predetermined but easy-to-maintain place, typically the Text1-4 properties in the workflow profile where you have the Process step (using .GetAttributeValue on the profile object).

    Terms & ConditionsAccessibility statement